Maintenance of automatic food waste treatment equipment

　　When it comes to pressing work, it is required to shut down the equipment when it is close to the curtain, and do not stop the operation of the equipment immediately. The first is to reduce the pressure of the four-column hydraulic machine body so that the pressed and dehydrated raw material slurry will open the pressing door at the end of the screen barrel; or to raise the pressing door according to the WeChat customer service hotline operation instructions, and then let the equipment run for a period of time until the raw material mud in the screen bucket cannot be discharged again, and then wait and sort out and eliminate the remaining raw material mud in the screen bucket;

　　During the operation of the machine and equipment, try to avoid excessive pressure, otherwise it will cause mechanical failure, such as a sudden stop of the machine or the rupture of the screen barrel;

　　The system management temperature of the column hydraulic press shall not exceed 65°C. Because the hydraulic pump is high-pressure and heats up quickly, I feel that the high-pressure gasoline pump does not work continuously for more than 30 minutes. In transmission system management, the temperature of each roller bearing shall not exceed 50°C;

　　During the operation of the automatic food waste processing equipment, do not allow sharp, hard objects and internal metal to be filled with liquid. These substances will harm various parts of the human body and endanger the normal operation of the machine and equipment. You can sort out the raw materials before squeezing;

　　If the machine is not used frequently, try to clean it with a water gun that contains slurry in the human body. Apply grease to easy-to-corrode parts for maintenance, and place them in an allergic area indoors;

　　The compressor lubricating oil controlled by the four-column hydraulic frame should be removed. When stepping on the accelerator or changing the oil, use a 130-mesh filter to filter the compressor lubricating oil;

　　In the transmission gear system management of automatic food waste processing equipment, each roller bearing should be restarted regularly to introduce grease for maintenance; the reducer should be restarted regularly to introduce grease for maintenance; the hydraulic oil filter element should be restarted regularly to introduce grease for maintenance.